Euro Domain
Tuesday, February 23, 2010
Update Phone Firmware Directly on Nokia XpressMusic 5800
Friday, February 12, 2010
Gong Hei Fatt Choi
Friday, February 5, 2010
FIFA World Cup Trophy Tour - Malaysia Leg
Wednesday, February 3, 2010
Toyota: What to Do When Accelerator Pedal Stuck?
Did you owned any Toyota car on the list below?
Certain 2009-2010 RAV4
Certain 2009-2010 Corolla/ Altis
2009-2010 Matrix
2005-2010 Avalon
Certain 2007-2010 Camry
Certain 2010 Highlander
2007-2010 Tundra
2008-2010 Sequoia
If yes, no need to freak out. Early January, Toyota in USA, Europe and China, had been issued massive safety recall on 8 affected models as listed above due to accelerator pedals stuck while driving. For details, please read here.
On their official website, Toyota had issue recommendations on what to do should the problem arise while driving. Excerpt from the official FAQ as below:
Each circumstance may vary, and drivers must use their best judgment, but Toyota recommends taking one of the following actions:
1. If you need to stop immediately, the vehicle can be controlled by stepping on the brake pedal with both feet using firm and steady pressure. Do not pump the brake pedal as it will deplete the vacuum utilized for the power brake assist.
2. Shift the transmission gear selector to the Neutral (N) position and use the brakes to make a controlled stop at the side of the road and turn off the engine.
3. If unable to put the vehicle in Neutral, turn the engine OFF. This will not cause loss of steering or braking control, but the power assist to these systems will be lost.
4. If the vehicle is equipped with an Engine Start/Stop button, firmly and steadily push the button for at least three seconds to turn off the engine. Do NOT tap the Engine Start/Stop button.
5. If the vehicle is equipped with a conventional key-ignition, turn the ignition key to the ACC position to turn off the engine. Do NOT remove the key from the ignition as this will lock the steering wheel.
For more information, please read here.